Table of Contents
Advertisement
H
ow to Proceed for tHe
tds g
old receiver
P
rogramming notes
The Skipper LCD and Skipper Senso have the same remote control memorisation
procedure. For this reason, in the following pages, we will refer to a generic "LCD remote
control" without specifying whether it is a Skipper Senso or an LCD.
On Skipper LCD, being a multi-channel remote control, it is necessary to select the device.
STORING OF THE FIRST REMOTE CONTROL
ATTENTION! This programming is only necessary when the motor or receiver is
installed for the first time, that is to say, when the receiver has not yet been connected
to any remote control. Otherwise, see: "Storing of other remote controls".
- Make sure that the motor or receiver is supplied with energy.
- Main menu / Programming / Device / Store + STORE
- After storing, use the UP / DOWN / STOP keys to check whether the motor is operating
correctly.
- After checking, press END PROCEDURE.
STORING OF OTHER REMOTE CONTROLS
Consult the following scheme in order to find the procedure that meets your requirements
and then follow the procedure found in the pages below:
To add:
To another device created using: Function:
LCD
Another Cherubini
remote control
remote control*
Another
LCD
Cherubini
remote control
remote control*
LCD
(another) LCD
remote control
remote control
*Remote control of the Skipper series (not LCD) or Giro series
LEGEND:
Tn / Cn: already stored remote control / channel (not LCD)
Tx / Cx: remote control / channel to be stored (not LCD)
LCDx: device to be stored on a LCD remote control
LCDn: device already stored on a LCD remote control
t
rX / w
ronic
:
rX / s
ave
enso
Tn/Cn
Skipper/Giro
ADD FROM
A+B; B
LCDn
LCD
remote control
ADD TO
ADD TO
LCDn
ADD TO +
LCD
remote control
ADD FROM ADD TO
39
rX
motors and for tHe
Procedure:
LCDx
LCD
remote control
ADD FROM
Tx/Cx
Skipper/Giro
B
(2 sec)
LCDx
LCD
remote control
ADD FROM
1
2
3
Advertisement
Table of Contents
