Table of Contents
Advertisement
ATTENTION! Even if the Skipper LCD remote control can be used for all
installation devices, it is advisable to use also other remote controls (single or
multi-channel ones) in order to control the devices in case of emergency (e.g.
flat batteries). Alternatively, we suggest using a wire remote control (white
wire for Tronic, Wave, Clima and Senso).
Programming the LIMIT-SWITCHES and the MIDDLE POSITION
The limit switches and the middle position of the stored devices
can be programmed using the same sequence of keys as those
used for other Cherubini remote controls. The UP/STOP/DOWN
commands correspond to the A/B/C ones.
Programming the LIMIT-SWITCHES (only for installers)
How to make the programming accessible:
- Deactivate the "Program Lock" (see SETTINGS, page 28), if it is active
- Path: Main menu / Commands / Devices / CREATED DEVICE
- Press the keys in the necessary sequence according to the instructions for using the
motor.
Programming the MIDDLE POSITION
How to make the programming accessible:
- Deactivate the "Program Lock" (see SETTINGS, page 28), if it is active.
- Path: Main menu / Commands / Devices / CREATED DEVICE.
- Move the device (rolling shutter/awning) to the desired position and then hold the middle
key down (for about 4 sec.) until the motor performs the confirmation movements.
Deleting the MIDDLE POSITION
If you want to delete the intermediate position, it can be done as described below.
To change this position, it's also necessary to delete first the memorised intermediate
position.
How to make the programming accessible:
- Deactivate the "Program Lock" (see SETTINGS, page 28), if it is active.
- Path: Main menu / Commands / Devices / CREATED DEVICE.
- Command: "Middle Position".
- When the device (rolling shutter/awning) has reached the middle position, press STOP
again (for abt. 4 seconds) until the motor performs the confirmation movements.
INFORMATION FOR THE INSTALLER
B
4 sec
38
A
B
C
Advertisement
Table of Contents
