Storing Of The Remote Control - CHERUBINI Skipper LCD Instructions Manual

STORING OF THE FIRST REMOTE CONTROL
ATTENTION! This programming is only necessary when the receiver (motor or control unit)
is installed for the first time, that is to say, when the receiver has not yet been connected
to any remote control.
Otherwise, see: "STORING OF OTHER REMOTE CONTROLS".
make sure that the receiver (motor or control unit) is powered.
- Main menu / Programming / Devices / DEVICE CREATED / Store + STORE.
- After storing, use the UP / DOWN / STOP keys to check whether the motor is operating
correctly.
- After checking, press END PROCEDURE.
STORING OF OTHER REMOTE CONTROLS
Consult the following scheme in order to find the procedure that meets your requirements:
To add:
Skipper LCD
Another Cherubini
remote control*
Skipper LCD
*Remote control of the Skipper series (not LCD) or Giro series.
- LEGEND:
Tn / Cn: already stored remote control / channel (not LCD)
Tx / Cx: remote control / channel to be stored (not LCD)
LCDx: device to be stored on a LCD remote control
LCDn: device already stored on a LCD remote control
Before proceeding
To another device
created using:
Another Cherubini
remote control*
Skipper LCD
(another) Skipper LCD ADD TO +
Function:
Tn/Cn
ADD FROM Skipper/Giro
A+B; B
LCDn
ADD TO Skipper LCD
ADD TO
LCDn
Skipper LCD
ADD FROM
ADD TO
29
PROCEDURE:
LCDx
Skipper LCD
ADD FROM
Tx/Cx Tx/Cx
Skipper/Giro Domi
B (2 sec)
LCDx
Skipper LCD
ADD FROM
1
2
3