Daily Use - Commands - CHERUBINI Skipper LCD Instructions Manual

In the Commands section it is possible to select a device or a group and move the motors
corresponding to the selection using the Up, Down and Stop keys or to activate a scenario
regardless of a programmed automation. According to the type of device or group (blind,
awning, etc.), further differentiated commands are available (Middle position, Light ON/
OFF automatic system). They can be made accessible by selecting "Other commands".
See Glossary  type of Device/Group, to find the correspondence between the commands
available and the type of Device/Group.
Quick starts can be used to make the commands of the SYSTEM STATUS screen
accessible. Before programming Devices, Groups and Scenarios, the related commands
are deactivated.
Description of the commands:
UP/DOWN: by pressing these keys only once, the device executes the command until the
stop command is given or until the maximum opening and closing positions are reached.
It is not necessary to keep the key pressed.
STOP: to stop the motor.
Middle position: the device is activated, until the set middle position is reached.
Light ON/OFF automatic system: it activates or deactivates the light sensor (only for
awnings).
How to activate a device:
Main Menu / Commands / Devices (or quick start: Down)
Select the chosen device from the list. Activate the desired commands (UP/STOP/DOWN or
Other commands). To quit: BACK.
How to activate a group:
Main menu / Commands / Groups (or quick start: Forward)
Select the chosen group from the list. Activate the desired commands (UP/STOP/DOWN or
Other commands). To quit: BACK.
How to activate a scenario:
Main menu / Commands / Scenarios (or quick start: Up)
Select the chosen scenario from the list. In order to activate it, just press the middle key.
To quit: BACK.

DAILY USE - COMMANDS

37