Installing And Removing The Propellers - Hubsan H122D X4 STORM User Manual

Installation: Push the battery into its
compartment with its lines facing away
from the unit. Connect it to the drone's
power line and coil the power line into the
compartment. Be
entangling the power line with the
propellers.
Make sure the battery is fully charged before each flight.
Please do not leave unattended while charging.
When charging is complete, disconnect the charger and battery from power immediately.
1.3 Installing and removing propellers
Propeller B
Propeller A
Installation: Before installing propellers for the first time, please check that each Propeller
A is matched with motor A and each Propeller B is matched with motor B. Align the "I" with
the flat side of the "D" shaped motor shaft. Then use the provided screws and screwdriver
to secure each propeller. Propeller A's are paired with black propeller screws and are
tightened counterclockwise. Propeller B's are paired with silver propeller screws and are
tightened clockwise. (as shown below)
careful to avoid
Propeller A
Propeller B
05