Installing The Hs001 Display - Hubsan H122D X4 STORM User Manual

1. Place the aircraft on a completely flat surface and then follow the below calibration
procedure. Hold the left stick to the right side of its socket. Rapidly and continuously wiggle
the right stick left and right until the rear red LEDS flash alternately.
2. Calibration is complete when the LED indicators stop flashing. It is recommended that
users wait for 15-20 seconds after the calibration is completed before flying again.
Hold the left stick to the right
side of its socket.
Before performing a Horizontal calibration, please make sure that all motors are
completely disarmed and that the aircraft is on a completely flat surface.

3.4.3 Installing the HS001 display

Option 1: Secure the HS001 display to the
HT015's mobile device bracket.
Rapidly and continuously
wiggle the right stick left and
right until the rear LEDS
flash alternately.
19