Table of Contents
Advertisement
Pre-condition:
Specifies how the reader goes to its current state as follows
0x00:
The reader has no card swipes and has not been authenticated since it was powered up.
0x01:
Authentication Mode was activated successfully. The reader processed a valid Activation
Challenge Reply command
0x02:
The reader receives a good card swipe.
0x03:
The reader receives a bad card swipe, or the card is invalid.
0x04:
Authentication Activation Failed.
0x05:
Authentication Deactivation Failed.
0x06:
Authentication Activation Timed Out: The host fails to send an Activation Challenge Reply
command within the time specified in the Activate Authentication Mode command.
0x07:
Swipe Timed Out: The user fails to swipe a card within the time specified in the Activation
Challenge Reply command.
12. Appendix A: Mounting Dimension Information
The bottom of the reader must be flat for mounting. If the reader needs to be mounted on the table,
please unscrew the two screws showed in red below. Those screws allow the two holes for
mounting. The mounting nut is M3x 3.
SecureMag Encrypted MagStrip Reader User Manual
Page | 53
Advertisement
Table of Contents
