Table of Contents
Advertisement
Response:
06 02 <Len_H> <Len_L> <MSR Data> 03 LRC
Other possible response statuses:
18 'Q' command length must be 1
•
18 Reader not configured for buffered mode
•
NAK Already armed
•
NAK for keyboard interface is FD, non-KB mode NAK is 15
6.10. Read MSR Options Command
02 52 1F 03 LRC
<Response> format:
The current setting data block is a collection of many function-setting blocks <FuncSETBLOCK> as
follows:
<STX><FuncSETBLOCK1>...<FuncSETBLOCKn><ETX><CheckSum>
Each function-setting block <FuncSETBLOCK> has the following format:
<FuncID><Len><FuncData>
Where:
<FuncID> is 1-byte identifying the setting(s) for the function.
•
<Len> is a 1-byte length count for the following function-setting block <FuncData>.
•
<FuncData> is the current setting for this function. It has the same format as in the sending
•
command for this function.
<FuncSETBLOCK> are in the order of their Function ID<FuncID>.
•
6.11. Set MSR Options Command
The default value is listed in bold.
6.11.1. Beep Volume
The beep volume and frequency can be each adjusted to two different levels or turned off.
02 53 11 01 <Beep Settings>03 LRC
Beep Settings:
'0' for beep volume off
'1' for beep volume high, low frequency
'2' for beep volume high, high frequency
'3' for beep volume low, high frequency
'4' for beep volume low, low frequency
SecureMag Encrypted MagStrip Reader User Manual
Page | 14
Advertisement
Table of Contents
