Power Button - Hayward OmniPL HLBPRO4SW Operation Manual

Home Screen
When the idle screen is touched, the OmniPL will display the Home Screen. This screen will give the
user access to all functions, settings and configuration options.

Power Button

The power button is displayed at all times when the OmniPL is not idle. When touched, it offers the
following 4 functions:
82
F
º
alarm
71º F
daylight
air
Shut Down - When Shut Down is selected, the OmniPL will turn off all pool equipment and report
when it is safe to remove power. When this message is displayed, you can either power off the unit
or restart the OmniPL by touching the large power button displayed on the left side of the screen.
Service Mode (page 29) - Service Mode will turn off all pool equipment and disable all remote con-
trols including networked devices. Service Mode is useful to prevent scheduled operation and dis-
able remote operation while servicing the pool. After selecting Service Mode, there are two options:
Service Mode (Standard): The OmniPL will remain in Service Mode until you manually exit. To
exit Service Mode, touch the power button and select the Service Mode button again.
Service Mode Timed: Before entering Service Mode, you will select a Service Mode timeout.
This is the amount of time that the OmniPL will stay in Service Mode before automatically exit-
ing. The timeout can be set between 1-96 hours. There is no need to exit Service Mode manu-
ally.
Features Off - Features Off offers a quick way to turn off all equipment with a single touch of a but-
ton. Note that the filter pump, heater, lights and chlorination will continue to run if scheduled.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
82
F
º
71º F
air
lights
favorites
alarm lights
daylight favorites
service
shut down
mode
features simple
off mode
4