Hayward OmniPL HLBPRO4SW Operation Manual page 31

2. Using an ordinary web browser, go to www.hayward.com/firmware and compare the latest
available version on the web to the current firmware version. If the firmware version on the
web is greater (number is larger) than your current version, upgrade your OmniPL's firmware.
If not, periodically check the website and upgrade as newer firmware is released.
Upgrading Firmware
1. Insert your USB thumb drive into your computer.
2. Go to www.hayward.com/firmware.
3. Click on the link to download the latest firmware and save to the USB thumb drive.
4. Turn off all pool equipment.
5. Remove power to the OmniPL's electrical panel.
WARNING - The thumb drive will always be inserted and removed with the power off.
6. Locate the USB port on the OmniPL Controller and insert the thumb drive.
7. Apply power to the OmniPL and allow enough time for the OmniPL to fully start.
8. Enter Service Mode.
9. Touch the Upgrade button.
con g
daylight
SERVICE MODE
main screen
10. Select "MSP and touch the Save button.
select device
component HUA
MSP 0-0-0-0
MP 1-65-0-2a-a6
COMPONENT
selection
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
msp id:3233
component HUA
MSP 0-0-0-0
MP 1-65-0-2a-d4
Relays 3-10-0-0-1
EcoStar pump 10-0-0-0-4e
EcoStar pump 10-0-0-0-54
SYSTEM INFO
(must be in Service Mode)
upgrade
sysinfo
current version
R.1.3.0
R.1.04
current firmware version
version
R2.0.0
R.1.0.2
R.1.0.2
R.3.0.4
R.3.0.4
component
MSP
MP
COMPONENT
selection
component
MSP
MP
COMPONENT
selection
select device
HUA current version
0-0-0-0 R.1.3.0
1-65-0-2a-a6 R.1.04
select device
HUA current version
0-0-0-0 R.1.3.0
1-65-0-2a-a6 R.1.04
30