Web Enabled Control - Hayward OmniPL HLBPRO4SW Operation Manual

Pool automation and chlorination

Hide thumbs Also See for OmniPL HLBPRO4SW:

Installation manual (65 pages)

Operation manual (44 pages)

Table Of Contents

Table of Contents

The OmniPL should have already been configured for use with the home's router to allow for remote

control through the web. This procedure is covered in the Configuration Wizard information found

in the Installation Manual. After configuration, an account must be created to allow access to the

OmniPL from web enabled devices. If this has not already been done by the installer, follow the

procedure below.

Using an ordinary web browser, go to www.haywardomnilogic.com. If you don't already have

an account, select "Register New User" and set up a new account.

OmniPL. When asked for your Time Zone, be sure to enter the same time zone as the physical

location of the installed OmniPL, otherwise schedules and timers will be inaccurate. You'll also

be asked for an MSP System ID. This number can be found directly from the OmniPL. To find

your unit's MSP ID, follow the procedure below:

MSP ID___________

After the MSP is accepted, the OmniPL will be linked to your account. You'll be able to access the

OmniPL at any time from your browser by logging into your account at haywardOmniPL.com. For

mobile devices, an application must be downloaded from your device's app store. Go to www.hay-

ward.com for more information on the availability and function of mobile apps.

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS