Installation - Njoy Soter 600 User Manual

3

Installation

The UPS can protect your equipment from all power problems such
as surge, spikes, blackouts, brownouts and line noise. When AC
power is present and the ON/OFF switch is turned ON, the UPS is
always charging the battery and provides power to the equipment
from AC line directly. A reliable built-in battery can provide stable
power in order for you to complete your work, save your data
and safely shut down your system when there is a utility power
blackout.
3.1 Connecting your equipment and first usage
The UPS is simple to operate and install. Please read the following
steps before connecting any equipments to this UPS:
Step 1. Connect the UPS to a grounded AC power outlets.
Step 2. Turn On the UPS by pressing the power button. The LED
on the button will light up.
NOTE: When the UPS is off and there is no power utility, it's
still possible to cold start the UPS unit to power the connected
equipment.
Step 3. Plug your equipment to Battery Backup Outlets of the
UPS.
CAUTION
Do NOT plug LASER
PRINTERS into any
of the outlets.
04
Do NOT plug any
SURGE STRIPS into
any of the outlets.
3.2 Indicators & Alarm Table for Operation
LED Alarm

Off
Sounding every 10
seconds.
Sounding every
second.

Off

Continuously sounding.

LED ON

LED OFF
LED Flashing
UPS Status
UPS is operating normally.
Power failure occurs and
UPS is on battery mode.
Low battery; the UPS will
shut down shortly.
UPS is off.
UPS fault
05