System Settings - T+A HA 200 User Manual

System settings

Meter mode
j
Source
configuration
Display
brightness
Display mode
Colour profile
Energy saver
j
Device info
Under this menu item the display mode of the meters can be set.
The following measurement types are available:
Input level -
Output level -
Temperature -
Signal quality
-
Meters off -
For detailed information on the various meter settings and display types, refer to chapter
„Meters" on page 50.
Under this menu item, sources which are not needed can be deactivated.
Deactivated sources can no longer be called up using the source buttons on the device
and the remote control.
After calling up this menu item with the
appears.
Each source is followed by a remark indicating whether the source is activated (ena-
bled) or deactivated (disabled).
Here you can adjust the brightness of the display during normal operation to your per-
sonal preferences in 9 steps.
Here you can set whether the display will be switched on permanently or only tempora-
rily, when the device is being operated.
If the setting temporary is selected, the display is switched on during operation of the
HA 200 only and then automatically switched off again after a short delay.
If the Always ON setting is selected, the display remains permanently on.
Under this menu item you can adjust the brightness of the status LEDs and the bright-
ness and illumination color of the meters to your personal preferences.
Select the menu item Default colours to reset the displays to the default settings.
The energy saving mode can be switched on and off here.
The machine has an Auto Power Down function.
If the ECO option is selected, the HA 200 automatically switches to standby mode if no
music signal and no operation is detected for more than 60 minutes.
If the Comfort setting is selected, the unit remains switched on until it is manually swit-
ched to standby mode.
In Ländern außerhalb der EU in denen die EuP Richtlinie nicht gilt, kann die automatische
Abschaltung des Gerätes (Einstellung ECO) bei Bedarf deaktiviert werden.
Menu item to display the installed firmware versions and the option to reset the device
to the factory default settings.
Level of the input signal
Level of the output signal
Temperature monitor of the device and the
Class A output stages
Displays the quality (frequency deviation and error rate) of
the input digital signal.
Meters switched off
button, a list of all sources of the HA 200
47