Exerpeutic Folding Upright Bike with Pulse Owner's Manual page 14

ASSEMBLY
Tool:
5mm Allen Wrench with
Phillips Screwdriver
1PC
Step 4
Place the Handlebar (4) onto the Front Frame (1), and remove the Console Cover (69) from the
back of the Handlebar (4). Turn the Tension Control Knob (13) to level 8 and hook the cable
end of the Tension Control Knob (13) into the cable lock of the Tension Cable (15) (See Fig
AA-3).
Hook the Tension Control Knob (13) cable into the slot at the top of the Tension Cable (15),
then gently remove the Clip (15A) after connecting the resistance cable of the Tension Control
Knob (13) and the Tension Cable (15) (See Fig AA-4), If you need more room lift the
handlebars up.
Connect the Computer Wire (9B) to the Sensor Wire (37) (See Fig AA-5). Then, Attach the
Console Cover (69) onto the back side of the Handlebar (4).
Attach the Handlebar (4) onto the Front Frame (1), with four Flat Washers (33) and Hexagon
Socket Bolts (58). Tighten the Hexagon Socket Bolts (58) by using the 5mm Allen Wrench
provided.
Hardware:
(33) Flat Washer
(58) Hexagon Socket Bolt
Ø8.2xØ16.8 4PCS
M8x15 4PCS
12