L-860 Led Elevated Light Fixture: Required Equipment; Table 2-1 Mounting Columns; Table 2-2 Required Equipment Supplied - ADB Signature Series L-860 Manual

L860 Elevated Low-Intensity Edge Light
1. Introduction
(contd.)
2. L-860 LED Elevated Light
Fixture: Required
Equipment
© 2008 Siemens Airfield Solutions
All rights reserved
See Figure 2-1 for the main items in the assembly. The ELIL is
assembled at the factory and is ready for installation. The ELIL is
typically supplied with a 1-1/2 -12 UNF threaded frangible coupling
for mounting on a L-867B light base. The housing assembly includes
the electronic package.
The fixtures can also be mounted on a L867D base plate with either a
1-1/2−12 UNF or a special 2 NPT frangible reducer coupling for an
existing installation that has 2-inch NPT hub. Base mounting is
recommended because maintenance is easier to perform.
The mounting column is available in three standard lengths. Refer to
Table 2-1.
NOTE: The measurements in Table 2-1 are taken from the grade to
the top of the light fixture.

Table 2-1 Mounting Columns

Type
Standard (FAA minimum)
Standard
Standard (FAA maximum)
Refer to Table 2-2 for required equipment that is supplied. Refer to
Table 2-3 for required equipment that is not supplied. Refer to the
Parts section for part numbers.

Table 2-2 Required Equipment Supplied

Description
Elevated light fixture (with optical column, frangible
fitting, LED module, and power cordset)
Instruction manual
96A0388B
Issued 6/08
Description
Overall Mounting Height -
inches. (mm)
14 (355.6)
24 (610)
30 (762)
Quantity
1
1
Page 2-2