Dismantling
1. Loosen the 4 screws 1 of the CPX-CMXX 2 with a
TORX screwdriver size T10.
2. Pull the CPX-CMXX 2 carefully and without tilting
away from the contact rails 3 of the manifold sub-
base 4.
Assembly
1. Place the CPX-CMXX 2 in the manifold sub-base 4.
Make sure that the grooves with the terminals for
electrical contact on the bottom of the CPX-CMXX 2
lie directly above the contact rails 3.
2. Then press the CPX-CMXX 2 carefully and without
tilting as far as possible into the manifold sub-base 4.
3. Place the screws 1 so that the self-cutting threads
can be used. Tighten the screws 1 at first only by
hand.
4. Tighten the screws 1 with a TORX screwdriver size
T10 with 0.9 ... 1.1 Nm.
Festo CPX-CMXX 1102b English
19