Check Oil Level; Change Oil - Taylor-Dunn Tiger TC-030-60 Operation, Maintenance, And Replacement Parts Manual

Maintenance, Service, and Repair

CHECK OIL LEVEL

1. Make sure the ignition switch is in the "OFF"
position.
2. Place the transmission shift lever in the Park or
Neutral position
3. Set the park brake.
4. Place blocks under the front wheels to prevent
vehicle movement.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle.
Failure to use lifting and support devices of rated
load capacity may result in severe bodily injury.
5. Park the vehicle on a level surface.
6. Remove the oil level plugs on the primary and
secondary reduction gear boxes.
7. The oil level should be very close to the bottom of
the level plug hole.
8. Reinstall the plugs.
Level Plug, Primary Case
Level Plug, Secondary Case
Drive Axle: MT-030-60-C
Page 2

CHANGE OIL

1. Make sure the ignition switch is in the "OFF"
position.
2. Place the transmission shift lever in the Park or
Neutral position
3. Set the park brake.
4. Place blocks under the front wheels to prevent
vehicle movement.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle.
Failure to use lifting and support devices of rated
load capacity may result in severe bodily injury.
5. Place an oil drain pan underneath the drive axle.
6. Remove the drain plugs on the primary (1) and
secondary (2) reduction gear boxes.
7. Remove the level plugs on the primary and
secondary reduction gear boxes.
8. Allow all oil to drain from the gear boxes and Install
the drain plugs.
9. Fill both gear cases with oil up to the bottom of the
level plug holes. Refer to Lubrication section for oil
specification.
10. Install the level plugs.
Drain Plugs