Vehicle Controls; Instrument Panel; Ignition Switch; Work Lights - Taylor-Dunn Tiger TC-030-60 Operation, Maintenance, And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS

VEHICLE CONTROLS

INSTRUMENT PANEL

1) Ignition Switch

Note: Rotary switch shown. Also
available as a keyed switch.
The ignition switch has 3-positions:
OFF, RUN, START.
Rotating the switch clockwise to the first
position turns the ignition system ON.
Rotating the switch to the START position engages the
engine starter motor. This is a momentary position and
the switch will return the START position when it is
released. Once the switch has been released from the
START position, it must be turned to OFF before it can
be turned back to the START position.

2) Work Lights

Pull the switch out to turn the rear work lights on. Push it
in to turn them off.
Safety Rules and Operating Instructions: MT-030-60-C
Page 4

3) Oil Pressure

This gauge indicates the
engine oil pressure, not the oil
level. However, if your engine's
oil level is low, it could affect
the oil pressure.
Typical normal oil pressure
range when engine is hot is 6
to 18 PSI.
With the engine running, the pointer should move into
the NORMAL range. If the pointer drops below the
NORMAL range while the engine is running, you have
lost oil pressure and continued operation will cause severe
engine damage. If the pointer exceeds the NORMAL
range then there may be obstructions in the engine
lubrication system and continued operation will cause
severe engine damage.
If the oil pressure is low, pull to the side of the road and
immediately shut the engine off. Check and add oil as
needed and restart the engine. If the oil pressure is still
low, turn the engine off and have the vehicle towed to a
repair facility.
If the oil pressure is high, pull to the side of the road and
immediately shut the engine off and have the vehicle
towed to your authorized Tiger Tractor repair facility.