Replace Front Wheel Bearings; Replace The Steering Cylinder; Rebuild The Steering Cylinder; Replace Ball Joint - Taylor-Dunn Tiger TC-030-60 Operation, Maintenance, And Replacement Parts Manual

REPLACE FRONT WHEEL
BEARINGS
It is recommended that if a wearable component is
replaced on one side of a vehicle, the same components
should be replaced on the other side of the vehicle.
This procedure assumes that the front hub has been
removed from the vehicle. Refer to the front hub assembly
removal instructions for details and warnings regarding
the removal and installation procedure.
1. Thoroughly clean all grease from the inside of the hub.
2. Use a race puller or press to remove the inner and outer
races.
3. Install new races.
Make sure the inner and outer bearing races are
pressed properly into the hub. Improperly pressed
races will result in premature failure of the bearings.
4. Pack inner bearing with appropriate grease and install in
the hub along with a new grease seal.
5. Apply a thin film of grease to the seal lip.
6. Slide the hub/bearing assembly onto the spindle being
careful not to damage the seal lip.
7. Pack outer bearing with appropriate grease and install in
the hub.
8. Reassemble the hub to the steering knuckle using the
inner bearing nut only at this time.
9. Refer to Adjust Front Wheel Bearings (New Bearings) for
procedure to adjust the wheel bearings.
New front wheel bearing adjustment must be
inspected after the first 24 hours of operation. This
includes new vehicle installations. Failure to inspect
the bearings after the break in period may result in
premature failure of the bearings.
Maintenance, Service, and Repair
REPLACE THE STEERING
CYLINDER
Refer to Steering Component Service section
REBUILD THE STEERING
CYLINDER
Refer to Steering Component Service section

REPLACE BALL JOINT

Refer to Steering Component Service section
Front Axle: MT-030-60-C
Page 5