Vehicle Controls; 1: Ignition Switch; 2: Headlight Switch; 3: Engine Oil Pressure - Taylor-Dunn TC-30 Operator's Manual

MT-030-60-E

1: Ignition Switch

Note: Rotary switch shown. Also available as
a keyed switch.
The ignition switch has 3-positions: OFF, RUN,
START.
Rotating the switch clockwise to the first position
turns the ignition system ON.
Continue rotating the switch to the START
position to engage the engine starter motor.
This is a momentary position and the switch will
return the ON position when it is released. Once
the switch has been released from the START
position, it must be turned to OFF before it can
be turned back to the START position.

2: Headlight Switch

Pull the switch OUT to turn the lights on. Push
it IN to turns lights off.

3: Engine Oil Pressure

Displays the oil pressure in the engine.
4: MIL (Malfunction Indicator Light)
If the MIL is on, it indicates the ECU has detected
conditions that the engine is not operating
correctly and the vehicle should be immediately
removed from service to be inspected by a
qualified technician.
The MIL should be on when the ignition switch
is ON but the engine has not yet been started.
If the light does not come on then the vehicle
should be immediately removed from service to
be inspected by a qualified technician.
Tiger TC-3060 Operator Manual

Vehicle Controls

5: Engine Coolant Temperature
Displays the temperature of the engine coolant.

6: Battery Volt Meter

Displays the battery volts. The voltage should
be in the green area of the gauge while engine
is running.
If it is in the red to the right of the green area,
then there may be a problem with the charging
system or battery. If in the yellow or red to the left
of the green area, then there may be excessive
load on the system or there may be a problem
with the charging system or battery. Refer
diagnosis to a qualified technician.

7: Fuel Gauge

The fuel gauge displays approximately how
much fuel is in the fuel tank only when the
ignition switch is ON. Do not refuel any vehicle
while the engine is running.
The fuel gauge indicator may vary slightly when
the vehicle is in motion. The most accurate
reading is obtained with the vehicle on level
ground.
With ignition switch OFF, the fuel gauge indicator
may drift from when the ignition switch is in the
ON position.
The fuel gauge is not available on LPG fuel
systems. Refer to the gauge mounted on your
LPG fuel tank.

8: Engine Hour Meter

Displays total hours of engine operation.
Page 19