Remove The Feeder From The Digitizer Base - 3D Systems VIDAR AdvantagePRO Series User Manual

4. Remove the Feeder from the Digitizer Base

19196-001 Rev. D
a. Remove the film support bar
from the top of the feeder
®
(DiagnosticPRO Advantage
®
and DosimetryPRO
Note: You must remove
the film support before
packing the feeder;
otherwise the feeder will not
fit into the foam support
b. Loosen the three thumbscrews securing the
feeder to the digitizer base.
c. Lift the feeder up and off the digitizer base.
VIDAR Advantage Series User's Guide
Advantage ONLY).
Screws
Film
Support
37