Top Led: Feeder Status; Center Led: Digitizer Status - 3D Systems VIDAR AdvantagePRO Series User Manual

Top LED: feeder status

LED state
Solid green
Off
Fast flashing green
Slow flashing green
Fast flashing green

Center LED: Digitizer Status

LED state
Solid green
Slow flashing green
Slow flashing green
Slow flashing green
Slow flashing green
Slow flashing green
Slow flashing green
Off
19196-001 Rev. D
Digitizer condition Corrective action
Ready None. The feeder is ready to operate.
ERROR: no feeder 1. Turn off digitizer.
attached 2. Remove feeder.
3. Inspect electrical connector and screws on
ERROR: unknown Check feeder:
feeder attached 1. Turn off digitizer.
2. Remove feeder.
3. Inspect electrical connector and screws on
BUSY: film is None. This is normal operation.
staging
ERROR: film Eject film by clicking the eject button in the
staging problem scanning application.
Digitizer condition Corrective action
Ready None. The digitizer is ready to accept commands
from the scanning application.
BUSY: normalizing None. This is normal operation. The LED will
flash slowly during initial calibration after power is
applied, and when the scanning application
initiates a calibration.
BUSY: tracking None. This is normal operation. The LED will
(ADC) flash periodically when the digitizer is idle.
Automatic Digitizer Calibration (ADC) is
independent of the scanning application.
BUSY: staging film None. This is normal operation. The LED will
flash slowly while the digitizer is staging the film.
BUSY: Positioning None. This is normal operation. The LED will
film flash slowly while the scanning application is
positioning the film.
BUSY: digitizing film None. This is normal operation. The LED will
flash slowly while a film is being digitized.
BUSY: ejecting film None. This is normal operation. The LED will
flash slowly while the scanning application is
ejecting the film.
ERROR 1. Make certain power is supplied to the digitizer,
2. If problem persists, get qualified technical help
VIDAR Advantage Series User's Guide
bottom of feeder.
bottom of feeder.
and that the digitizer power switch is on.
(see "In case of difficulty," later in this chapter).
30