Replacing The Lamp Cartridge - 3D Systems VIDAR AdvantagePRO Series User Manual

Replacing the Lamp Cartridge

19196-001 Rev. D
All Advantage Models
WARNING: The lamp cartridge assembly is specific to each
Advantage Model. Ensure you have the correct replacement
lamp Cartridge before installing the new lamp.
Contact VIDAR Technical Support if you have any questions
about installing or using your VIDAR film digitizer:
Phone: +1.800.471.SCAN (+1.800.471.7226)
+1.703.471.7070 outside the U.S.
E-mail: mailto:medtech@3dsystems.com
Follow the instructions in "Cleaning the Diffuser," earlier in this chapter, but work with
the new lamp cartridge in steps 5 through 10.
Preventive maintenance is not covered under warranty. (Only failures during the
published warranty period are covered by warranty replacement. Failures must be
confirmed by running VIDAR's Digitizer Diagnostic Tool. The software generates a
report showing light values indicative of lamp performance. You can request a copy of
the Digitizer Diagnostic program from VIDAR Technical Support.)
VIDAR Advantage Series User's Guide 28