Installation; Mounting Gun To Rod; Mounting Gun To Stationary Support Or Robot Arm - Graco A Series Instructions - Parts Manual

Automatic plural component, impingement mix spray gun for use with non-flammable foam and polyurea, not for use in explosive atmospheres

Hide thumbs Also See for A Series:

Table of Contents

Installation

To mount the gun on a 1/2 in. diameter rod, insert

the bar (A) through the hole in the gun body as

shown.

Secure the gun to the bar by tightening 1/4 in. - 20

mounting screws.

Mounting gun to stationary

support or robot arm

To mount gun to stationary support or robot arm, see

mounting hole dimensions page 20.

Two .128 in.

alignment

pin holes

310649C

ti4750a

Two 1/4 -

20 unc

holes

ti4751b

Installation

Table of Contents