Table of Contents
Advertisement
Setup
Install Tip/Guard Assembly
(if not installed)
Reversible Tip Selection Chart
MATERIALS
*Thin
Thin stains,
semi-transparent stains
211, 411
*Install Fine-Finish Optimizer, see page 9.
1.
Engage trigger lock and put prime/relief valve UP to
release pressure.
ti14994a
2.
Install filter to Spray Tip/Guard Assembly (make sure
filter is fully installed into sprayer). NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
ti14775a
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid damage to the filter.
3. Screw Tip/Guard Assembly onto sprayer. Tighten
retaining nut until completely engaged with sprayer.
NOTICE
The tip is a permanently attached to the Tip/Guard
Assembly. Removal will result in damage.
3A1456A
Medium
Heavy
Enamels, solid
Heavy latex
stains, thin latex
213, 413
315, 515, 517
ti14999a
Shoulder Strap Installation
1. Attach the metal eyelet to the back of the sprayer.
2. Open the velcro end of the strap, then route it
through the slot under the tip of the sprayer.
3. Route velcro up through the metal triangle, then fold
down and attach velcro to strap.
11
Advertisement
Table of Contents
