Table of Contents
Advertisement
Modifications and use outside of intended scope
This device has been designed and tested to conform to all applicable
standards in the original form and when configured with the components
shipped with the device. It is not permissible to modify the device, use the
device for any use outside of the intended scope, or use the device with
any antenna other than the one shipped with the device.
Important Pilot Advisory Note Regarding Safety of Radio Frequency
Energy
Safe use of this device requires care as to the placement of the internal
antenna. Place the antenna at least 4cm away from any part of your body
or that of other cabin occupants. To stop all RF emissions, remove power
from the equipment or configure the equipment for receive mode only.
Retain these instructions with your maintenance logs/files and for future
reference.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits (Table 1 of
47Pt1 (i) 1.1310) set forth for a Public/Uncontrolled environment.
Mode-S or ATCRBS (UK)
EC Devices do not replace the need for a transponder when required by
airspace/flight rules. Aeronautical Information Circular (AIC) Y 141/2019
allows for the use of EC devices simultaneously with ATCRBS or Mode S
transponders which are not Extended Squitter (ES) or ADS-B OUT
enabled. If your aircraft is ADS-B OUT enabled, you must disable the
transmit function of SkyEcho from the configuration settings. Receive
functionality may still be used. Deactivation of the transmitter is
accomplished by removing device power or disabling the transmit capability
via the configuration settings. These regulations are subject to change.
Please be informed of the most current regulations at:
https://www.caa.co.uk/General-aviation/Aircraft-ownership-and-maintenance/Electronic-
Conspicuity-devices/
UAV-1002156-001
ECCN 7A994
Page
15 | 37
REV I
Advertisement
Table of Contents
