Table of Contents
Advertisement
Making Measurements
Making single-ended OE measurements
82
bandwidth reduction factor is set in the file
LCAConfig.xml.
b Click
to proceed.
c When asked whether you want to save the data
• If you can use this calibration data again, click
give your calibration data file a name, and save it.
Make sure "Also save the LCA Settings" is selected if you
also want to save the complete LCA setup.
See "Saving and Loading Setups" on page 61 for more
information about LCA setups.
• If you will have no need to reuse or refer to this
calibration data, click
1 Connect your device under
test.
2 When the message is
displayed, click
to start the
measurement.
3 To make further
measurements with these
settings, press
to start the measurement.
For information on further parameters, please refer to "User
Interface Reference" on page 57
Keysight N4374B Lightwave Component Analyzer, User's Guide
.
or
DUT
or
,
in
out
Advertisement
Table of Contents
