Replacing The Glass Insert - Siemens FDM223 Technical Manual

7.4 Replacing the glass insert

007002_k_en_--
Manual call points FDM223H and FDM224H
The glass insert is square-shaped and can be inserted in any direction.
CAUTION
Risk of cutting injuries when removing the glass fragments
Remove the glass fragments carefully
To replace the glass insert, proceed as follows:
w The door of the manual call point is open. See the chapter 'Preparation'.
1. Remove all the remains of the old glass insert.
2. Insert the new glass insert between the guides (1) and slide it down as far as
the stop behind the retainer (2).
– You may need to manipulate the glass insert slightly before it will slide into
the retainer (2).
a
The glass is fitted in the door.
3. Check the function of the manual call point.
4. Close the door.
a The glass insert has been replaced.
1
Figure 22: Replacing the glass insert
1 Guides
1
2
2 Holder
Maintenance / Repair
Replacing the glass insert
7
45 | 54