Master And Crm Functionality; Clock And Timer; Master Functions - D&R Sirius Manual

Processing

5.6 Master and CRM functionality

This broadcast mixer has extensive monitoring and master features. You have a Clock, a
Timer, On-Air indication, assignable meters and CRM source selection. This all is located in
the upper section of the display as shown below.

5.6.1 Clock and Timer

Situated left in this master section
you see an analog type clock
producing the actual time. The
next section houses the Timer and
its controls. The Timer is accurate
down to 1/10 of a second. You can
start the Timer by clicking the
Start button or by assigning the Timer to a fader-start (see 7.2 Input and output )
The Stop knob stops the Timer when started by the Start knob or fader-start.
The Reset button shall reset the Timer to 00:00:00:00

5.6.2 Master functions

In the master section you will also find the red light signaling. This is located below the Clock
itself on the screen. When a channel is activated and you have labeled this channel to generate
red light (see 7.2 Input and output ) only then 'On-Air' light shall be activated.
NOTE:
Red light signaling is active for both Red-light 1 and Red-light 2 busses, however both busses
can be assigned individually to the remotes of course.
Below the Timer you see three knobs: CUE Reset, Conference talk-back and Panic. These
knobs have the following functions.
CUE Reset
Conference Talk-back When this knob is activated your CRM mic will be added to the CUE
Panic
Sirius digital Mixer from D&R Phone +31 294 418014, email:
Resets all active Cues.
buss. All outputs, selected as part of the 'Conference Talk-back'
(see 7.2 Input and output ) shall be switched to the CUE buss to
be able to listen to the CRM Mic.
This function shall provide you with the default setting to be
loaded instantly when necessary. In this way you always get a
known setting back in your console when you are lost in
programming.
info@d-r.nl Page 14