LifeSpan Pursuit 2 User Manual page 27

Code
Unable to
Control Speed
No Power
Abnormal
Motor Torque
Motor
burnt out
Incline cannot
be controlled
Power
Interruption
Reason Solution
B. Check IGBT on bottom control board
is burnt out. Test the above reasons
and change the relevant part.
Refer to E03.
A. Check the fuse.
B. Check that the power plug terminal
is in good contact with the
controller.
A. Check whether the motor condition
and motor belt tension. Replace
motor if necessary.
B. If motor is in good condition,
replace control board or IC.
A. Check if the control is also burnt.
B. Replace the motor.
C. Replace the controller.
A. Check incline motor power wire and
3 pin line connection with
controller.
1. Remove the display wire installed
on the controller (safety lock),
turn on the power, press down on
the small key on the right corner
of controller 2 seconds.
2. The incline motor will initiate an
automatic signal detection
procedure. The motor will ascend
to the highest level then descend
to the lowest level.
3. When the motor reaches the
lowest level, after 3 seconds, the
procedure will be over.
4. After the procedure, connect
the display wire (or the safety
key). Operate the display function
and test the incline function.
B. Change the controller.
A. Check if the power wire is
connected well.
B. Check wire – controller connection.
TROUBLE SHOOTING GUIDE | 27