Putting The Machine Out Of Service; Disposing Of The Unit; Instructions For Disposal - John Bean EHP System III-E Operator's Manual

40
7.0 Putting the machine out of
service
In case the machine is not be used for a long period of time (6
months or more) it is necessary to disconnect air and power
discharge the bead seater tank (if provided),
service,
protect all parts that may be damaged from environmental
, protect the air hoses that may be damaged
intrusion
by the drying process.
When putting the machine back in operation, check the con-
dition of all previously protected parts, and check for correct
functioning of all devices before using the machine again.

8.0 Disposing of the unit

To dispose of the equipment at the end of its life,
contact the reseller for a quote or for the regulations
on disposal which apply to the unit.
This symbol indicates that separate collection
of waste electrical and electronic equipment is
mandatory for scrapping.

8.1 Instructions for disposal

For electrical and electronic equipment
European directive 2002/95/EC, 2002/96/CE and
2003/108/EC (RAEE)
At the time of disposal, at the end of the lifetime of
this equipment, you must:
1. Render the machine inoperative, remove the plug
and cut off the power supply cable close to where
it comes out of the machine.
2. DO NOT dispose of the equipment as urban
waste and recycle it, by taking the materials to
suitable recycling centres.
3. Contact the reseller for the closest authorised
recycling centres for the disposal or for the
collection of old equipment when purchasing new
equipment.
4. Stick to the standards for correct waste management,
to prevent potential effects on the environment and
human health. Unauthorised disposal will result in
administrative sanctions for the offenders.