Installation; Electrical Installation - John Bean EHP System III-E Operator's Manual

2.0-1
16
540.tif

2.0 Installation

Install the machine in a covered and dry place.
Operation temperature is +41/+122 °F (+5/50° C). The
machine can work below 32 °F (0° C), but some minor
modifi cations are required: contact your JBC distributor
for detailed information.
A. Remove the screws that attach the machine to
the pallet.
B. Lift the machine with an appropriate lifting tool (crane,
fork lift) and a belt of suffi cient capacity (3500 N).
For this operation, it is required to be helped by a
second person. Always mind the center of gravity of
the machine (Fig 2.0-1).
BE CAREFUL NOT TO DAMAGE THE AIR HOSES.
C. Remove the safety means from the mounting arm.
D. When fi rst setting the machine into operation, check
hose connections and unions for leakage.
E. The machine must be secured to the fl oor through
the holes provided in the cabinet.
Expansion screws 12x120mm shall be used.
Drill 12mm holes in the floor flush with the holes
provided in the cabinet.
Place the nogs into the holes drilled in the fl oor and
move the machine so that the holes of the cabinet are
fl ush with the holes in the fl oor. Tighten the screws at
70 Nm (51 ftxlb).

2.1 Electrical Installation

WARNING
ALL ELECTRICAL CONNECTIONS SHALL BE
PERFORMED BY A LICENCED TECHNICIAN.
ALL SERVICE MUST BE PERFORMED BY AN
AUTHORIZED SERVICE TECHNICIAN.
FOR ELECTRIC MOTOR TYPE ONLY:
Check that the electrical specifi cations of the power
source are the same of the machine. The machine uses
0.75 kW. Electric specifi cations are clearly marked on
a label at the end of the electric cord.
If the plug is provided disregard this paragraph.
Connect the electric cord of the machine with an
approved plug. The ground cable (green and yellow)
must be properly connected.
WARNING!
FAILURE TO PROVIDE PROPER ELECTRICAL
SUPPLY AND GROUNDING WILL CREATE A SHOCK
HAZARD TO THE OPERATOR.
NOTE: AIR MOTOR POWERED MACHINE
D O E S N ' T N E E D E L E C T R I C A L
INSTALLATION.