Maintenance - John Bean EHP System III-E Operator's Manual

5
6
7
C
A
38
6.0-1
6.0-2
8
B
6.0-3

6.0 maintenance

WARNING
BEFORE ATTEMPING ANY MAINTENANCE OR
REPAIRS THE MACHINE MUST BE DISCONNECTED
FROM THE AIR AND ELECTRIC SUPPLY.
A. Periodically clean the vertical hexagonal rod with
nonfl ammable liquid detergent. Lubricate with oil (Fig.
5.4).
B. Periodically clean all moving metal parts and
lubricate with oil.
XXXX.tif
C. Clean the teeth of the clamps with a wire brush,
check the plastic rim protectors and replace if worn
(Fig. 5.5).
D. Peridically replaced the plastic insert inside mount/
demount tool.
E. Lubricate rods of air cylinders with oil as needed.
F. Periodically wash all plastic parts with cold water and
soap or window cleaner.
G. Check the bead breaker pads. Replace if worn.
H. Discharge the water every day from air fi lter. Do this
by pulling down the fi tting 'B' (Fig. 6.0-3).
I. The machine is equipped with an automatic lubricator.
Check the oil level weekly.
When adding oil to the lubricator, disconnect the air
supply fi rst, remove the cup 'A', and add oil as needed.
Make sure seals are in place when repositioning the cup
L. Check oil dosage: After operating the pedals (6 e 8,
Fig. 6.0-3) 2 - 3 times, one drop of oil should fall into the
sight glass. If necessary adjust using the dosing screw
(C, Fig. 6.0-3).
WARNING! PAY ATTENTION TO KEEP FILLED
THE OIL TANK OF THE OILER, EXPECIALLY FOR
AIR MOTOR OPERATED MACHINES.
WARNING! USE ONLY OILS FOR AIR DEVICES,
DO NOT USE BRAKE FLUID OR OTHER NOT
SUGGESTED LUBRICANTS.
Suggested oils for the fi lter/lubricator unit:
TAMOIL:
SHELL:
BP:
TOTAL:
ESSO:
1059.tif
WHITE MINERAL OIL 15
ONDINA OIL 15
ENERGOL WT 3
LOBELIA SB 15
MARCOL 82