Table of Contents
Advertisement
External interfaces
List of bus IDs and source IDs
When operations are performed on external panels, crosspoint setting commands are issued that specify the materials (Source)
for the buses (Destination).
When this unit receives the crosspoint setting command from the external panel, materials are selected and video transitions
are executed according to the bus and material combinations specified in the command.
This section describes the IDs (numbers) used by this unit to identify each bus and each material.
IDs can be categorized broadly into the following 2 types:
1) Normal bus IDs and material IDs
IDs that specify the buses inside the switcher (ME1PGM, AUX1, etc.) and the switcher materials (SDI IN1, CBGD1, STILL1-V,
etc.).
Use a number between 1 and 512.
2) Extended bus IDs and extended material IDs
IDs used for playback of video transitions, macro memories, and shot memories.
When this unit receives a crosspoint setting command in which the same extended ID is specified for the bus and the
material, the corresponding function is executed.
For example, when a command is received that specifies the ME1 AUTO material (ID: 522) for the ME1 AUTO bus (ID: 522),
an AUTO transition is executed at ME1.
Use a number between 513 and 1023.
Executable operations
ME key transition
ME key transition (CUT)
ME AUTO transition
ME CUT transition
DSK transition
DSK transition (CUT)
Playing back macro registered memories
Playing back shot memory registered memories
p p Consult LAWO for details on how to assign IDs to the operations of each of the buttons on the LBP series.
Specified bus and material
ME1 KEY1 AUTO to ME1 KEY3 AUTO
ME1 KEY1 CUT to ME1 KEY3 CUT
ME1 BKGD AUTO
ME1 BKGD CUT
DSK1 AUTO to DSK2 AUTO
DSK1 CUT to DSK2 CUT
MACROPLAY1-1 to MACROPLAY9-9
SHOTPLAY1-1 to SHOTPLAY9-9
146
Advertisement
Table of Contents
