Verification Before Power-On; Powering On The Switch - HP A10500 Series Manual

Figure 33 Set terminal emulation in Switch Properties dialog box

Verification before power-on

Before powering on the switch, make sure:
x
You know where the emergency power-off switch for the equipment room is located.
x
The switch has been securely mounted.
x
All the cards have been correctly installed.
x
The unused slots have been installed with blank filler panels.
x
All the network cables, fibers, power cables, and grounding cables have been correctly connected.
x
The input power voltage meets the requirement of the switch.
x
The console cable is properly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.

Powering on the switch

Turn on the power source of the switch to power on the switch.
The following is a sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare.
The Extend BootWare is self-decompressing...................................
.....Done!
39