Testing The Connectivity - HP A10500 Series Manual

Remove the dust plug of the transceiver module, plug one end of the optical fiber into the
3.
transceiver module, and plug the other end into the transceiver module in the peer device, as
shown in
The transmit port on one end must connect to the receive port on the other end.
Check the port LEDs for incorrect connection.
4.
For more information about the LED status, see the chapter "Appendix C LEDs."
WARNING!
To avoid injury to your eyes, do not stare at the optical interfaces and optical fiber connectors when
connecting optical fibers.
Figure 34 Use LC optical fiber connectors to connect transceiver modules

Testing the connectivity

After you plug the switch into the network, use the ping or tracert command to test the network
connectivity. For more information about these commands, see HP A10500 Switch Series Command
References.
Figure 34.
LC plug
SFP module
44