HP A10500 Series Manual page 22

Figure 12 Install cable management brackets on an A10504
(1) Attach the cable management bracket to the
chassis
(3) Screws for fixing the cable management bracket to
the chassis
Installing the mounting brackets
Before installing the switch to the rack, install the mounting brackets to the chassis. Marks L and R are
printed inside the mounting brackets to distinguish between the left and right mounting brackets. To
install the mounting brackets, face the front of the switch, and mount the left and right mounting brackets
to the two sides of the switch, as shown in
Figure 13 Install the mounting brackets (A10508)
1
(1) Screws for fixing the mounting brackets to the chassis
(3) Signal cable management brackets
3
2
(2) Screw holes for installing the cable management
bracket
(4) Power cable management bracket (installed at the
lower part of the chassis)
Figure 13.
3
2
(2) Mounting brackets
19
1