Installing Accessories To The Chassis; Installing Mounting Brackets And Cable Management Brackets - HP A10500 Series Manual

Figure 10 Install the cage nuts (A10508 as an example)
(1) Cage nuts
NOTE:
When preparing for installation, make sure that the total height of the switches to be installed is no higher
than the available installation height of the rack, and reserve enough clearance for cable routing.

Installing accessories to the chassis

Installing mounting brackets and cable management brackets

Before installing the switch to the rack, install the cable management brackets and mounting brackets
shipped with the switch. Cable management brackets (signal cable and power cable management
brackets) are used for cabling the switch, and mounting brackets are used for fixing the chassis to the
rack.
Installing the cable management brackets
You must install the signal cable management brackets separately for the A10508-V switch. All other
A10500 switches come with the signal cable management brackets secured to the mounting brackets. In
this step, you only need to install the power cable management brackets for them.
1
1
1
1
1
1
17