Installing A Fan Tray; Replacing A Transceiver Module; Replacing An Xfp/Sfp+/Sfp Module - HP A10500 Series Manual

Figure 39 Remove a fan tray
(1) Loosen the captive screws on the fan tray

Installing a fan tray

To install a fan tray:
Wear an ESD-preventive wrist strap and make sure the wrist strap makes good skin contact and is
1.
well grounded. For more information, see the chapter "Installing modules."
Take out the fan tray from its package.
2.
Holding the handle of the fan tray with one hand and supporting bottom with the other, gently slide
3.
the fan tray along the guide rails into the slot until it is firmly seated in the slot.
Fasten the captive screws on the fan tray.
4.

Replacing a transceiver module

NOTE:
Make sure the optical transceiver modules at the two ends of an optical fiber are of the same model.

Replacing an XFP/SFP+/SFP module

To replace an XFP/SFP+/SFP module:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded. For more information, see the chapter "Installing modules."
(2) Take the fan tray out of the chassis
54