Appendix B FRUs and compatibility matrixes
MPUs
The main processing unit (MPU) is the core of the control management plane for the HP A10500 Switch
Series. The HP A10500 Switch Series supports the MPU LSU1SUPA0.
Table 27 LSU1SUPA0 supervisor engine specifications
Item
Interfaces
Interface transmission
rate
Cables and max
transmission distance
MPUs are ordered separately. An A10500 switch requires one MPU to operate normally. You can also
install two MPUs in an A10500 switch for redundancy.
LPUs
The LPUs in
Table 28 LPU specifications
LPU model
LSU1TGS1
6SC0
LSU1TGS8
SE0
LSU1GT48
SE0
LSU1SUPA0 supervisor engine
x
One console port for local or remote dialup configuration management
x
One 10/100/1000BASE-T interface for management and upgrade
x
Console port: no greater than 1 15200 bps and defaults to 9600 bps
x
10/100/1000BASE-T interface: 10/100/1000 Mbps, half/full duplex
x
Console port: 15 m (49.21 ft) over common asynchronous serial interface cable
x
10/100/1000BASE-T interface: 100 m (328.08 ft) over Category-5 twisted pairs
Table 28
apply to all the A10500 switches.
Description
16-port
10-Gigabit SFP+
optical Ethernet
interface card
8-port 10-Gigabit
SFP+ optical
Ethernet interface
card
48-port
10/100/1000Ba
se-T Gigabit
Ethernet interface
card
Number of
Connector
interfaces
LC
16
LC
8
RJ-45
48
63
Interface
Available
transmission rate
transceiver modules
x
x
10 Gbps, 1 Gbps
x
x
x
10 Gbps, 1 Gbps
x
10/100/1000
Mbps, half/full
N/A
duplex
10-Gigabit SFP+
module
10-Gigabit SFP+
cable
Gigabit SFP
module
10-Gigabit SFP+
module
10-Gigabit SFP+
cable
Gigabit SFP
module