Replacing An Sfp+ Cable - HP A10500 Series Manual

Remove the optical fibers on the XFP/SFP+/SFP.
2.
Pivot the clasp down to the horizontal position.
3.
Grasp the clasp on the module and carefully pull the module out of the socket.
4.
Put the dust plug on the removed module, and put the remove module into its original shipping
5.
materials.
Install a new XFP/SFP+/SFP module. For the installation procedures, see the chapter "Installing
6.
modules."
WARNING!
x
Do not stare at the fibers to avoid hurting your eyes.
x
When installing or removing an XFP/SFP+/SFP module, do not touch the golden finger of the module.

Replacing an SFP+ cable

To replace an SFP+ cable:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded. For more information, see the chapter "Installing modules."
Gently press the SFP+ cable plug in, and then pull the handle on the SFP+ cable outward to pull out
2.
the SFP+ cable plug.
Install a new SFP+ cable. For the installation procedures, see the chapter "Installing modules."
3.
NOTE:
x
Make the bend radius of the SFP+ cable at least eight times of the cable diameter.
x
Replace an SFP+ cable with care. If the SFP+ cable cannot be removed or installed, check that the
removal or installation procedures are correct.
55