Removing Cable Management Brackets And Mounting Brackets - HP A10500 Series Manual

Figure 52 Remove the chassis (A10508) from the rack
(1) Loosen the captive screws that fix the mounting
brackets to the rack
Put the chassis onto the pallet base of the wooden carton.
5.

Removing cable management brackets and mounting brackets

Before repackaging the switch chassis, remove the cable management brackets and mounting brackets
from the chassis.
Removing the mounting brackets
To remove the mounting brackets:
Prepare the packing box of the mounting brackets. Make sure that the box is clean, dry, and not
1.
damaged.
As shown in
2.
brackets to the chassis, and then remove the mounting brackets.
1
1
Figure 53, use a Phillips screwdriver to loosen the screws that fix the mounting
(2) Slide the chassis outwards along the slide rails
91
2
2