Throttle Trigger Interlock - Stihl MS 441 Manual

12.3.2 Throttle trigger interlock

– Remove handle moulding,
b 12.3.
: Drive out pin (arrow) with
a punch.
1
: Remove trigger interlock (1).
: Drive out bushing (1).
– Remove leg spring.
90
– Examine trigger interlock (1),
leg spring (2) and bushing (3),
replace if necessary.
2
: Align leg spring (1) and insert in
trigger interlock.
: Slide bushing (2) into hole
(arrow) to secure leg spring in
place.
1
1
1
2
2
3
– The leg (arrow) of the leg spring
must rest against the tank
housing.
: Centre trigger interlock (1) with
punch (2).
– Drive in the pin until it is
equidistant on both sides.
– Reassemble in the reverse
sequence.
– Tightening torques, b 3.5.
1
– Check correct operation.
MS 441, MS 441 C