Shroud, Removal And Installation - Stihl MS 441 Manual

8.4 Shroud, removal and
installation
1
– Remove carburetor box cover,
b 14.1.
: Pull boot off spark plug (1).
1
: Unscrew slotted nut (arrow).
: Lift shroud (1) off decompression
valve (2).
: Pull off stop buffer (1) and
examine it, fit a new stop buffer if
necessary.
44
2
1
: Pull off rubber grommet (3) and
remove slotted nut (1).
: Examine slotted nut (1),
insulating element (2) and rubber
grommet (3), replace if
necessary.
1
2
– Slide slotted nut (1) with
insulating element into hole.
: Fit rubber grommet (2) until it
engages the groove in the slotted
screw.
1
1
: Ease out rubber grommet (1) and
examine it, fit a new grommet if
necessary.
3
: Press rubber grommet (1) in until
the groove (arrow) engages the
rebate (2) in the housing.
– Use STIHL Press Fluid for easier
insertion, b 17.
2
1
– Remove filter base, b 14.1.2.
: Push out rubber grommet (1) and
examine it, replace if necessary.
1
: Pull grommet (1) in until the lug
(arrow) has been pulled in
completely.
– Use STIHL Press Fluid for easier
insertion, b 17.
1
2
MS 441, MS 441 C