Carburetor Support - Stihl MS 441 Manual

1
3
: Fit throttle cable (1) between
impulse hose (2) and fuel hose
(3), then hook it into carburetor
support (arrow).
Machines with handle heating
If the throttle cable retainer is
replaced, ensure that the wiring is
routed correctly (arrows).
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5.
114

14.6.1 Carburetor support

1
2
1
– Remove carburetor, b 14.3.
– Remove switch shaft, b 12.1.
: Take out sleeves (1) and remove
washer (2).
2
3
: Pull out throttle cable (1), impulse
hose (2) and fuel hose (3).
1
: Press rubber lips (arrows) of
intake elbow out through the
openings in the carburetor
support (1) towards the cylinder.
2
– Remove carburetor support.
: Disconnect ground wire (1) from
contact spring (arrow).
1
2
: Remove air guide inlet (1) and
air guide outlet (2).
: Pull off preheating plate (1).
– Remove contact spring b 9.6.2.
1
1
1
MS 441, MS 441 C