Axis 2N Indoor View User Manual page 78

3.2.5.5 Syslog
®
2N Indoor View
state and process information to a syslog server for recording and further analysis or
auditing of the device observed. It is unnecessary to configure this service for
common operations.
List of Parameters
Send Syslog Messages – enable sending of syslog messages to the Syslog server.
Make sure that the server address is valid.
Server Address – set the IP/MAC address of the server on which the Syslog
application is running.
Severity Level – set the severity level of the messages to be sent (Error,
Warning, Notice, Info, Debug 1–3). Debug 1–3 level setting is only recommended
to facilitate troubleshooting for the Technical Support department.
2N TELEKOMUNIKACE a.s., www.2n.cz
allows you to sends syslog messages including relevant device
78/112