Accessing The Analyzer Probe Port - Watts AERCO Benchmark BMK750 Operation And Service Manual
With edge (i) controller
Hide thumbs
Also See for AERCO Benchmark BMK750:
- Operation and service manual (213 pages) ,
- Installation and start-up manual (62 pages) ,
- Design manual (12 pages)
Table of Contents
Advertisement
Benchmark with Edge [I]: Operation-Maintenance Manual
SECTION 4 – INITIAL START-UP
Accessing the Analyzer Probe Port
4.2.3
Benchmark units contain a 1/4" NPT port on the side of the exhaust manifold, as shown in
Figure 4-2. Prepare the port for the combustion analyzer probe as follows:
Analyzer Probe Port Access Instructions
1. Refer to Figure 4-2 and remove the 1/4" NPT plug from the exhaust manifold.
2. If necessary, adjust the stop on the combustion analyzer probe so it will extend mid-way into the flue
gas flow. DO NOT install the probe at this time.
EXHAUST MANIFOLD
ANALYZER PROBE
Figure 4-2a: Analyzer Probe Port Location – BMK750 & 1000 Shown
OMM-0145_A99 • GF-218 •
PORT
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
9/18/2019
AIR INLET
HOT WATER INLET
CONDENSATE DRAIN
Page 54 of 157
Advertisement
Table of Contents
