Operation; Test Mode Without A Print Job; Test Mode With Print Job - CAB 4114 Service Manual

9

Operation

9.1

Test Mode without a Print Job

Warning!
!
The pad will be moved to the starting position immediately!
Danger of injury to hands and fingers by the moving pad!
 Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry away.
1
2
Fig. 34 Test mode using the enter button
i
Note!
 Please use the test mode to adjust the parameter "peel position" in the printer configuration.
The whole labelling process can be simulated without the need of a print job or a connection to a computer by alter-
nately pressing the feed (2) button and the Enter button
 Press the feed button (2).
A blank label is fed. The vacuum at the pad as well as the supporting air (blow tube) are switched on. After the
label has been picked up by the pad, the supporting air is switched off.
 Press the Enter button
The pad is moved to the labelling position. A sensor signals when the labelling position is reached. The vacuum is
switched off and the label is placed onto the product. Then, the pad is moved back into the starting position.
9.2

Test Mode with Print Job

i
Note!
 Please use that test mode to adjust the peel-off offset in the software.
That method allows to check labelling process with the real print data using the Enter button
 Send a print job.
The test mode is executed in two half cycles:
 Press the Enter button
Half cycle 1
A label is printed. The vacuum at the pad as well as the supporting air (blow tube) are switched on. After the label
has been picked up by the pad, the supporting air is switched off.
 Press the Enter button
Half cycle 2
The pad is moved to the labelling position. A sensor signals when the labelling position is reached. The vacuum is
switched off and the label is placed onto the product. Then, the pad is moved back into the starting position.
If the label is manually removed from the pad after the first half cycle, the half cycle 1 will be repeated when the
pre-dispense button is pressed again.
(1).
(1).
(1) again.
(1):
33
(1).