General Parameter Structure - Leuze electronic BPS 37 Technical Description

Leuze electronic
9.2.2

General parameter structure

Using the BPSConfig program, parameters can be changed via the service interface. These
parameters are divided into individual folders.
The following folders are available:
Measurement Value
Control
The various setting options are con-
tained in the folder Measurement
Value Control. These are used for
activating or deactivating the meas-
urement process.
Measurement Value
Measurement value ranges can be
defined in this folder. If the meas-
urement values rise above or drop
below these values, the BPS should
respond appropriately.
Settings can be made in this folder
for controlling how the BPS reacts
to the application of a 24 V signal.
Leuze electronic
Monitoring
Switching input
Communicating with the Device
Measurement Value
Preparation
This folder contains the parameters
which can be used to prepare the
measurement value. This includes
e.g. setting the initial or pre-set
value, the scaling setting, the count-
ing direction or the resolution.
In this folder the activation and
deactivation as well as the timing of
the switching output are defined.
This folder contains all settings nec-
essary for integrating the BPS to a
control or drive system via an SSI
interface.
BPS 37
Switching output
SSI Interface
33