EDITION 12/ 2008
OPERATING MANUAL
8
REPAIR WORK
➞ See safety regulations in chapter 2.
Incorrect maintenance/repair!
Danger to life and equipment damage
SIHI_0048_GB
8.1
EXCHANGE OR CLEANING OF FILTERS
Pump
Note
The in line fi lter should be fastened externally, but close to the gun, for example on the
reciprocator arm, but not on the gun insert.
1. Place opening 22 of the spanner on adapter (1) and hold.
2. Turn rod fi lter assy. (2) by hand to the left (anti-clockwise) and unscrew.
3. Remove rod fi lter (3) with lifting screw (4) from the housing.
4. Remove compression spring (5) from the housing.
5. Rinse fi lter (3) and the compression spring (5) and the handle sealing washer (6) with
cleaning solvent or replace it with a new one. Assemble in reverse order.
8.2
ADJUSTMENT OF THE VALVE ROD SEAL
In case paint leaks at the valve rod near the area (A):
1. Pull trigger and thoroughly clean paint channel
with solvent.
2. Tighten the sealing screw (4) carefully with
universal spanner.
3. If leaking continues, see chapter 8.3
PART NO. 350741
WARNING
Only a WAGNER service center or a suitably trained person may
carry out repairs and replace parts.
Only repair and replace parts that are listed in the chapter "Spare
parts catalog".
Before all work on the unit and in the event of work interrup-
tions:
- Disconnect the control unit from the mains.
- Relieve the pressure from the spray gun and unit.
- Secure the spray gun against actuation.
Observe the operating and service instructions when carrying
out all work.
6 5
2
GA 2000EAC, GA 2005EAC
1
3
4
Gun
36